SCHEMA PRINCIPLE : FLUE BOILER + STORAGE TANK + SOLAR WATER HEATER
The dual heat injection valve is not necessary if low-voltage solar pumps (recommended) is used.
See other schemas
1a : Regulator ° C on smoke (sensor)
1b : Regulator ° C on water (sensor)
2 : Automatic air vent high T°C
3 : Safety valve 3 bar gauge
4 : Termovar 61°C or 72°C
5 : pump heating flue boiler side
6 : heating circulator heating side
7 : Expansion tank inflating 1.5 bar
8 : Injection of anti-thermal valve boiling
9 : Check valve and anti thermosyphon
10 : Tacosol FV 70 (explanatory note below)
11 : Panel solar water heater
12 : Storage tank combined two exchangers
13 : Stove, fireplace, fireplace stove or wood boiler
14 : heat exchanger Bouilleurs de France
15 : Flue gas connecting conduit
16 : Water supply network (filling)
17 : Evacuation to sewer
18 : Permanent water supply network (hot water heating)
19 : Central heating thermostat control
20 : Heaters (or heated floor)
21 : Use domestic hot water
Specifications for utilization flue boiler and solar
Lighting the fire with T < C of TERMOVAR
The flue (15) warms up, water flue boiler (14) begins to warm up but does not flow immediately. Once the minimum temperature set on the thermal switch (1) it will activate the pump (5). Water circulates but still supplied the coil exchanger tank (12) as the temperature of thermal inversion TERMOVAR (4) is not yet reached.
The correct setting of the control sensor stainless steel (1) ensures a temperature always higher than smoke which occurs "fouling" the vent (15). This accessory provides decommissioning the pump (5) in the fire extinguishing phase.
Fire lit with T > C of TERMOVAR
Once the circulating water temperature reaches thermal inversion TERMOVAR (4), it is directed to the heat exchanger coil storage tank and water storage will begin to warm up. The domestic hot water tank (inner tank bath) will follow the rise in temperature. It is recommended to connect the flue boiler to the heat exchanger coil storage tank located at the top.
If no charging wood stove (13) is made, the fire will decrease. Before the flue gas temperature drops below the minimum threshold, the thermal regulation (1a and 1b) cut the flow of water to prevent excessive cooling. It is highly recommended to choose a "manual" mode to perform this function, temperature startup and shutdown are of paramount importance to ensure good performance of the system and to maintain the duct discharge in a normal state and minimum contamination.
Solar the day
During the day sunlight will heat water panels production (11) to be installed at a suitable location at the optimum result.
TACOSOL the system (10) will allow the control of the party solar water heater, its main functions are:
- Measurement and flow control circuit for optimum performance
- Connecting the expansion tank
- Safety valve pressure included
- Pump Wilo 25/6 included
- Two thermometers control back and tour / panels
- Pressure gauge needle
- Isolation Valves
The connection is made on the second exchanger coil at the bottom of the balloon. Stratification of the water storage allows the hottest water up to the top and so keep the hot water tank (in water bath) at the highest temperature. Warming of this part hot water is permanent which reduces its volume 100 or 150 liters.
Solar the night
At night the system is at rest. No hot water !
Central heating in service
Depending on the programming and control thermostat from room temperature (19), the pump (6) will be commissioned to ensure the flow of water in the distribution system (radiators (20) or underfloor heating) . It is important to calculate the volume of water storage to the needs of the home and the desired autonomy. Be careful not to oversize the storage volume.
In the case of a floor heating appropriate regulation should be put in place to allow use of the water in the tank (high temperature) with the floor (very low temperature), usually with a motorized valve 3 or 4 channels controlled sensor.
In summer the solar water heater will keep the hot water at a high temperature.
The winter, cold and overcast for a long time, the start of the heat source of wood will be required for the additional missing without any need to use fossil fuels (and expensive breakdowns) , to provide both the function of producing sanitary hot water, and also the need to provide heating of the house
Bouilleurs de France is a registered trademark and has a patent.
SARL BOUILLEURS de FRANCE au capital de 50 000 € - RCS de Bergerac n° 800 968 190 - APE n° 2521ZZ
SCHEMA DE PRINCIPE BOUILLEUR + BALLON + CHAUFFE EAU SOLAIRE
visits to the website :
Save on your energy bills !!
On may 21, 2013
Monday to Friday
9:00 to 12:00
14:00 to 18:00
Thank you for
Bouilleurs de France
it is the intelligent heating, which quickly pays for itself !
Heating most economical and ecological to warm you thanks to the smoke of your fireplace or your stove.
An innovative way to produce hot water, a perfect blend between wood burning and solar.
Our product does not cause any additional consumption of wood, it uses waste heat from the smoke stack.
Technical information, a quote, estimates, contact us by phone at
05 53 57 01 47
or by mail to
To ensure your comfort of navigation no advertising will be published on our site.