Bouilleurs de France is a registered trademark and has a patent.
SARL BOUILLEURS de FRANCE au capital de 50 000 € - RCS de Bergerac n° 800 968 190 - APE n° 2521ZZ
Hello Mr. Roux
I want to keep you informed of the progress of my installation.
Since the beginning of my installation I did change some details.
I powered my 4-way valve to reduce the amount of water to be heated by the boiler (only the volume of radiator circuit preventing the water through my boiler to minimize losses).
The valve also asked me some problems, I do not know if you have concerns, but I replaced the latter by a / 4 turn valve 1 motorized. (operation more reliable I think).
I also added a limit switch which opens the valve of the boiler only when the four-way valve is fully position heaters isolation circuit.
In the winter of my pump has passed away (22 years), I took the opportunity to replace it with another in self-adaptive flow.
Remember, I installed the boiler on a stove, who may not be subject to many calories, I think a fireplace insert the problem of inertia is less felt. It is true that I reduce the flow through the boiler to prevent excessive temperature fluctuations.
Here is the feedback about my system!
Sunday I met a friend, Mr. S. ........ who also wants to change the heating system. We were on your site, it will possibly contact you!
The drill pipe above my fireplace insert does not pose any particular problem, tracing and cutting the grinder rented for the occasion.
The boiler is set up easily on a length of about 50 cm above the nozzle connection with the adapter 150/154 mm.
The re-start is connected to a flexible duct 150 mm. I still use a wall mounting collar to keep up.
The water connection is against the current as I chose.
Once closed wall opening my corner fireplace is more "design" before and my wife is delighted. More than some painting to do!
The first outbreak and the result exceeds my expectations. Stainless steel switch trips after only 15 minutes of heating and water is already hot. It was not until half an hour and radiators distribute heat sufficiency. Once stabilized the system I see an average of 60 degrees out and 50 back. This difference tends to decrease after several hours of operation when the ambient temperature is higher.
I send you some pictures that will show you the small connection box which I added a neon lamp that tells me the state of the electrical circuit.
The setting of the switch is 75 degrees which corresponds to 150 after you smoke. Let me know if this sounds right?
C150 to insert fireplace Bergerac
The flue boiler is finally installed and running for 2 weeks. I had no problems installing, no problem and purge the system works perfectly. One small problem, I think the engine throttle is warmer than the water through the pump. Do you think this is normal?
The outside temperature starts to drop and I'll see the performance of the device.
The flue boiler is connected to three radiators of the house and I do not see this feeling cold at the other end of the house as the last winter, and the boiler is completely extinguished.
The boiler is fitted directly to the output of the insert and above the boiler is also directly connected to the casing of the chimney and therefore I did not use both connections "Poujoulat" you m 'were sold. So I will return these two parts that do not serve me and I think you will repay me.
Otherwise, I've used all the other rooms without a problem.
I will also put a comment on a forum, because I think your really awesome system.
Regarding safety in the event of a power a friend who has installed a slightly different system, advises me to do the backup power from a 12V battery and a device that converts 12V to 220V.
This allows for a few hours waiting to lower the heat in the insert.
C150 on insert fireplace in Lillebonne (76)
My house is small, in the countryside and very poorly insulated. I have an old stove in my basement and some electric heaters that ate a lot.
Since I installed your flue boiler that I no longer use it to heat my bathroom, my bedroom and my living room. 3 radiators I asked with an additional 55 liters of hot water heater also heated by the flue boiler
Today it is 3 degrees outside and I'm 24 ° inside and 25 ° in the bathroom with the heat to low, this is too much, but I am comforted in the days when the temperature will be -10 °.
I'm sure to make great savings on my heating bill this year thanks to you burning only wood. More high EDF bills that put my little retreat undermined.
I am pleased to have invested in this system (in total almost € 3,000 with labor and the ball), thank you for your flue boiler of a frightening effectiveness !
Fursac to (23)
You can download the PDF report after installation at one of our clients in Poitiers Vienne (86000). Using our C150 exchanger mounted on the exhaust of a wood log boiler is perfectly analyzed duct.
Note that the use of the boiler is not permanent which extends the amortization period. The hot water produced is sent to 1600 liters of storage exchanger Bouilleurs de France increased by 11% the efficiency of the boiler.
C150 on wood boiler Geminox in Poitiers (86)
The opinions by our customers
visits to the website :
Save on your energy bills !!
On may 21, 2013
Monday to Friday
9:00 to 12:00
14:00 to 18:00
Thank you for
Bouilleurs de France
it is the intelligent heating, which quickly pays for itself !
Heating most economical and ecological to warm you thanks to the smoke of your fireplace or your stove.
An innovative way to produce hot water, a perfect blend between wood burning and solar.
Our product does not cause any additional consumption of wood, it uses waste heat from the smoke stack.
Technical information, a quote, estimates, contact us by phone at
05 53 57 01 47
or by mail to
To ensure your comfort of navigation no advertising will be published on our site.